Unpacking The Appliance; Overview Of The Components; Initial Operation; Using The Appliance - CTC CLATRONIC DB 3717 Mode D'emploi

CAUTION:
This appliance is not intended for immersion in water during
cleaning. Please refer to the instructions provided in the chapter,
"Cleaning".

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Remove all packaging materials such as films, filler
material, cable clips and carton.
3. Check the contents for completeness.
4. In case of incomplete delivery or damage, do not operate
the appliance. Return it to your dealer immediately.
NOTE:
Production residue or dust may have collected on the ap-
pliance. We recommend cleaning the appliance according
to chapter "Cleaning".

Overview of the Components /

Scope of Delivery
1 Steam nozzle
2 Heating control light
3 On / off switch
4 Handle
5 Water tank
6 Button for water tank removal
7 Steam switch
7a Locking button of the steam switch
8 Textile brush attachment
8a Lint insert
Notes for Use
Attachments
- Without attachment:
Vertical steam ironing for hanging garments
- Textile brush attachment:
For a gentle and efficient method to eliminate creases on
textiles. (Place the attachment in a way that the clamp for
opening is facing downwards.)
- Lint insert:
For smoothing and removing lints. (Install the insert in a
way that the steam holes are not covered.)
Locking Button (7a)
You may use the locking button for continuous steam gener-
ation (see "Using the Appliance").
• If you want to release the locking button, push it back up.
DB3717_IM
Electrical Connection
• Make sure that the appliance voltage (see name plate)
and the line voltage match.
• Connect the mains plug to a properly installed shock-
proof socket only.
Connected Wattage
The total power consumption of this appliance can be up to
1100 W. Do not use any multiple sockets, as this appliance
is too powerful.

Initial Operation

Fill in Water
NOTE:
Refilling with water is not possible during operation.
1. Remove the water tank by pressing the buttons (6) on
both sides. Remove the water tank by pulling it forward.
2. Above the water tank is a stopper. Pull it off.
3. Fill the water tank with water.
NOTE:
• Do not exceed the marking MAX.
• Use distilled water to prevent limescale.
4. Close the water tank again with the stopper.
5. Put the water tank back into the appliance.
NOTE:
If possible, the spherical end of the suction tube should
always be on the ground for the water to be sucked easily.

Using the Appliance

CAUTION:
• Do not operate the appliance without water!
• Check the water level during operation.
1. Plug the power plug into the wall socket.
2.
NOTE:
If necessary, fit an attachment.
3. Turn on the appliance using the on / off button at the back
of the appliance.
31
04.12.18