Pre-Operation Checks - Honda UMK435T Manuel De L'utilisateur

5.

PRE-OPERATION CHECKS

For safe and efficient trimming, always make a pre-operation
inspection before operating:
Perform a pre-operation inspection on a firm, level surface with the
engine stopped and make sure that the engine switch is in the OFF
position.
1. Check the engine oil level
Running the engine with low oil level will cause serious engine
damage.
1. Place the grass/weed trimmer on a level surface and remove the oil
filler cap.
2. Check the oil level: it should reach to the edge of the oil filler neck,
and check the engine oil for contamination and deterioration.
3. If the oil level is low, fill to the edge of the oil filler neck with the
recommended oil.
If the oil is contaminated or deteriorated, replace it (see page
4. Install the oil filler cap.
Every 10 hours, check the engine oil level and replenish oil up to the
top of the oil filler neck if the engine is operated for more than 10
hours continuously.
ENGINE OIL CAPACITY:
OIL FILLER NECK
UPPER OIL LIMIT
20
0.10 L
UPPER OIL LIMIT
ENGINE OIL
FILLER CAP
44 ).