Unpacking And Checking The Contents; Selecting The Location; Making The Connections - Ivoclar Vivadent VP5 Mode D'emploi

4. Installation
4.1

Unpacking and checking the contents

Remove the pump from its packaging and check it for any
transportation damage. We recommend keeping the
original packaging for any transportation purposes. Use
only the original packaging for shipping.
4.2

Selecting the location

Place the pump on a flat surface using the rubber feet
(12). Make sure the pump is not exposed to direct sun-
light. Do not place the pump in the immediate vicinity of
heaters or other sources of heat. Make sure that there is
enough space for air circulation between the wall and the
air vents (3).
Make sure to select the location in such a way that the
sound absorber is not knocked off by accidentally abutting
against laboratory furniture.
4.3

Making the connections

Checking the rating plate and power supply
Make sure that the voltage indicated on the rating plate
(11) complies with the local power supply. Should this not
be the case, do not connect the pump.
Connecting the vacuum hose
Remove the protective cap (10) from the vacuum hose
connection (4) and slip the vacuum hose on the vacuum
hose connection (4).
Connect the other end of the vacuum hose with the
furnace.
Please check if the hose is properly connected.
Connecting the power
Plug the power plug of the power cord (2) into the
corresponding socket in the Programat. This is the power
supply at the same time.
8
10
The electrical installation in the room where the
pump is used must comply with the local and IEC
requirements.