Environmental Instructions; Technical Information - V-ZUG Vertica Mode D'emploi

Changing Lamps
Disconnect the exhaust hood from the po-
wer supply! To change the halogen lamps,
carefully remove the glass cover with a small
screw driver, remove the bulb and replace it
with a new bulb. Avoid direct contact between
the bulb and the finger. Replace defective
bulbs with new ones immediately.
Malfunctions
Please consult our customer service
immediately if the following malfunctions
occur:
- The exhaust hood is making unidentifiable
noises and you cannot determine a
malfunction after inspection;
- You determine that the motor is
malfunctioning or defective, such as after
hearing strange noises;
- The switch is not functioning properly.
Please be certain to provide the type
designation of your model as well as the
accompanying serial number. You will find
this information on the type label. This is
located inside the hood, near the filter.
Disposal
Packaging
The packaging of the exhaust hood is
recyclable. Cardboard and polyethylene foil
(PE) are used as packaging materials. The-
se materials are environmentally compliant
and should be disposed of as per the valid
regulations of the respective location.
Exhaust Hood
Your community will inform you about the
environmentally friendly disposal of old
household appliances.
Environmental
Instructions
All V-Zug models are labeled as per
European Directive 2002/96/EG on Waste
Electrical and Electronic Equipment (WEEE).
This guideline provides the basic conditions
valid for the EU-wide return and recycling of
old appliances. Please consult your dealer
for the current disposal methods.

Technical Information

Connection to the electrical network:
220-240V / 50-60 Hz, 600W, option 300W
Halogen Bulb Type:12V, 20W Sockel G/4 21520
en