Putting Into Operation; Technical Data - DS Produkte 05783 Mode D'emploi

Putting Into Operation

1. Unpack the items supplied and remove all protective fi lms
and stickers. Check all parts for possible transport damage.
If you fi nd any transport damage, contact the customer
service department immediately.
2. Screw the LED light into a suitable lamp fi tting (E27).
3. Switch on the LED light by switching on the light switch on
the lamp and pressing the AN / AUS (on / off) button (1) on
the remote control. The light begins to rotate after it has
been switched on.
4. Use the control pad for colour selection (5) to select a
colour or a colour combination.
5. When you press the Farbwechsel (colour change)
button (6), the 5 basic colours light up alternately. Press any
colour selection button to switch off colour change mode.
6. Use the speed setting buttons (4) to set the speed of
rotation of the LED light.
7. Use the brightness setting buttons to set the brightness of
the LED light.
8. When you press the Musik-Sensor (music sensor)
button (2), the LED light fl ashes with the rhythm of the
music which is currently playing. Press the Musik-Sensor
button again to switch off the music sensor.
9. To switch off the LED light, press the AN / AUS (on/off)
button (1).

Technical Data

Article number:
Model number:
Fitting:
Voltage supply:
Light:
Remote control: 3 V DC (1 x 3 V button cell, CR2025 type)
15
05783
LM-085S
E27
100-240V~ 50/60Hz, max. 5.5 watt
EN