IMG STAGELINE TXS-865HT Mode D'emploi page 10

To unmute the microphone, press the but-
ton / once again .
6) The transmitter is provided with a lock func-
tion to prevent accidental change of settings
or switching off
7) To switch off the transmitter, keep the button /
(2) pressed until the display shows
the transmitter is switched off .
5.1 Setting the transmitter
When the transmitter is not locked, press the but-
ton SET (4) to activate the setting modes one after
another:
group (keep button pressed for a while)  channel
 sensitivity  transmission power
 automatic frequency matching
 identification number  lock function
To make settings in a setting mode, see the corre-
sponding chapter 5 .1 .1 to 5 .1 .6 .
To exit a setting mode without changing a setting,
press the button SET repeatedly until the display
briefly shows
the normal mode .
5.1.1 Transmission frequency (group / channel)
To set the transmitter quickly and easily to the
transmission frequency of the receiver unit, use
the REMOSET function (
However, it is also possible to set the transmission
frequency of the transmitter manually by selecting
the channel group and the channel . The table on
page 20 gives an overview of the groups and
channels .
1) Keep the button SET (4) pressed until the display
briefly shows
( . . . ) starts flashing; the group setting mode
is activated .
2) Select the group with the button  (3) or the
button  (5) .
3) Press the button SET to confirm . The channel
indication starts flashing on the display; the
channel setting mode is activated .
4) Select the channel with the button  or the
button  .
5) Press the button SET to confirm . The display
briefly shows
the normal mode .
10
☞ chapter 5 .1 .6 .
. The unit will then return to
chapter 5, step 3) .
☞
. Then the group indication
. The unit will then return to
5.1.2 Sensitivity
For the microphone sensitivity, several levels are
available: from 12 dB (maximum sensitivity) to
−18 dB (minimum sensitivity) .
1) Keep the button SET (4) pressed until the display
briefly shows
. Then
mode (group indication starts flashing) .
2) Press the button SET repeatedly until the dis-
play briefly shows
sensitivity .
3) Press the arrow buttons to set the sensitivity in
such a way that you obtain an optimum volume
level of the microphone . If the volume is too
high, the microphone will distort; in this case,
set a lower value with the button  (3) . If the
volume is too low, there will be a poor signal-
to-noise ratio; in this case, set a higher value
with the button  (5) .
4) Press the button SET to confirm . The display
briefly shows
the normal mode .
5.1.3 Transmission power
For the transmission power, two values are avail-
able . With a high transmission power, the range
will increase; however, the operating time of the
batteries will decrease due to faster discharge .
1) Keep the button SET (4) pressed until the display
briefly shows
mode (group indication starts flashing) .
2) Press the button SET repeatedly until the display
shows the current transmission power:
low transmission power (10 mW)
high transmission power (50 mW)
3) Press the button  (3) to select the setting
or press the button  (5) to select the setting
.
4) Press the button SET to confirm . The display
briefly shows
the normal mode .
and then the group setting
and then the current
. The unit will then return to
and then the group setting
. The unit will then return to