Applications; Conformity And Approval; Setting Into Operation; Inserting The Batteries - IMG STAGELINE TXS-606HSE Mode D'emploi

Pocket Transmitter
with Tie Clip Microphone
These instructions are intended for users without any
specific technical knowledge . Please read these instruc-
tions carefully prior to operating the unit and keep them
for later reference .
All operating elements and connections described can
be found on the fold-out page 3 .
1 Overview
1 Transmitting antenna
2 On / off switch
OFF
STDBY = sound muted
ON
3 Display to indicate
1 . the channel group (GROUP 00 – 09)
2 . the channel (CHANNEL 00 – 99)
3 . the battery status
4 Sensor for the IR signals to set the channel
5 Battery compartment cover
6 Jack (mini XLR, 3 poles, unbal .) to connect an electret
microphone
7 Belt clip
8 Control GAIN for the microphone signal
9 Battery compartment
2 Important Notes
The pocket transmitter corresponds to all relevant direc-
tives of the EU and is therefore marked with
•
The pocket transmitter is suitable for indoor use only .
Protect it against dripping water and splash water, high
air humidity and heat (admissible ambient temperature
range 0 – 40 °C) .
•
For cleaning only use a dry, soft cloth; never use water
or chemicals .
•
No guarantee claims for the pocket transmitter and no
liability for any resulting personal damage or material
damage will be accepted if the pocket transmitter is
used for other purposes than originally intended, if it
is not correctly operated, or if it is not repaired in an
expert way .
If the pocket transmitter is to be put out of
operation definitively, take it to a local recy-
cling plant for a disposal which is not harmful
to the environment .
6

3 Applications

To provide a wireless audio transmission system, combine
the pocket transmitter TXS-606HSE with the following
receivers from IMG STAGELINE:
TXS-606 with 1 receiver unit
TXS-626 with 2 receiver units
TXS-646 with 4 receiver units
TXS-686 with 8 receiver units
Set the transmission frequency on the receiver
(672 .000 – 696 .975 MHz, frequency spacing 25 kHz) .
Then simply press a button and, via IR signal, the pocket
transmitter is matched to the channel selected on the
receiver (ACT function = automatic channel targeting) .

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that the
pocket transmitter TXS-606HSE complies with the di-
rective 2014 / 53 / EU . The EU declaration of conformity is
available on the Internet:
www .img-stageline .com
Restrictions or requirements apply in the following
countries:
In the Federal Republic of Germany, the pocket trans-
mitter requires a frequency assignment (for which a fee
is charged) .
In other countries, it is necessary to apply for a corre-
.
sponding approval . Prior to operating the pocket trans-
mitter outside Germany, please contact the MONACOR
subsidiary or the corresponding authorities of the respec-
tive country . Links to the national authorities can be found
via the following Internet address:
www .cept .org
t ECC
t Topics
t Other spectrum topics: SRD Regulations and indica-
tive list of equipment sub-classes
t EFIS and National Frequency Tables

4 Setting into Operation

4.1 Inserting the batteries

For operating the pocket transmitter, two 1 .5 V batteries
of size AA are required .
CZ DE EL
IT LT MT
FI FR
PL