Getting Started; Remote Sensor Installation; Main Unit Installation; Connect Ac Adapter - Oregon Scientific RAR502SX Manuel De L'utilisateur

GETTING STARTED

REMOTE SENSOR INSTALLATION

1. Step applicable only to THGR221:
Open the battery compartment cover.
2. Slide channel switch to select channel 1. Ensure
you use a different channel for the other sensors
(2, 3).
3. Insert the batteries, matching the polarities.
4. Press TEST after each battery change.
5. Replace the battery compartment cover.

MAIN UNIT INSTALLATION

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities.
3. Press RESET after each battery change.
The battery icon may appear in the following
areas:
AREA
Main unit
Main unit batteries low
environment area
Remote sensor Remote sensor batteries
environment area low
MEANING
4
NOTE
We recommend that you use alkaline batteries with
•
this product for longer usage and lithium batteries in
temperatures below freezing.
Batteries should not be exposed to excessive heat
•
such as sunshine or fire.

CONNECT AC ADAPTER

Connect the supplied power adapter to the power jack,
then plug into a standard AC outlet.
NOTE
The batteries are only for back-up use.
•
Make sure the adapter is not obstructed and is
•
easily accessible to the unit.
• The base station and adapter should not be exposed
to wet conditions. No objects filled with liquid, such
as vases, should be placed on the base station and
adapter.
SENSOR LOCATION AND SYNC AND
PLACING SENSORS
The main unit will automatically search for new sensor
reset within the last 30 minutes. If main unit failed to
synchronise with remote sensor, reset both the main
unit and sensor or try selecting a different channel, then
reinstall the batteries and press TEST.