Danby DPAC8511 Guide D'utilisation Et Soins De Propriètaire page 8

Features
ELECTRONIC CONTROL
INSTRUCTIONS
MODE select button
1
Selects the appropriate operating mode. Each time you press the
button, a mode is selected in a sequence that goes from AUTO,
COOL, DRY, FAN and HEAT(cooling only models without HEAT
feature). The mode indicator light illuminates under the different mode
settings.
TIMER button
2
Used to initiate the AUTO ON start time and AUTO OFF stop time
program, in conjuction with the up arrow & down arrow buttons.
POWER button
3
Power switch on/off.
SLEEP button
4
Used to initiate the SLEEP operation.
FAN button
5
Control the fan speed. Press to select the fan speed in four steps-
LOW, MED, HI and AUTO. The fan speed indicator light illuminates
under different fan settings except AUTO speed. When select AUTO
fan speed, all the fan indicator lights turn dark.
UP and DOWN buttons
6
Used to adjust (increasing/decreasing) temperature settings (1°C/2°F
increments) in a range of 17°C(62°F) to 30°C(88°F) or the TIMER
setting in a range of 0~24hrs. The control is capable of displaying
temperature in degrees Fahrenheit or degrees Celsius. To convert
from one to the other, press and hold the Up and Down buttons at the
same time for 3 seconds.
7 LED Display
Shows the set temperature in °C or °F and the Auto-timer settings.
While on DRY and FAN modes, it shows the room temperature.
Error codes:
E1 - Room temperature sensor error-Unplug the unit and plug
it back in. If error repeats, call for service.
E2 - Evaporator temperature sensor error- Unplug the unit and
plug it back in. If error repeats, call for service.
E4 - Display panel communication error - Unplug the unit and
plug it back in. If error repeats call for service.
P1 - Bottom tray is full - Connect the drain hose and drain the
collected water away. If error repeats, call for service.
8 ION button(optional)
Press the ION button, the ion generator is energized and will help to
remove pollen and impurities from the air, and trap them in the filter.
Press it again to stop the function.
SWING button
9
Use this button to initiate the auto swing feature or lock the louver at
the desired positon.
7