Operating Instructions; Setting The Direction Of Rotation - EUFAB TÜV GS Manuel De L'opérateur

5. OPERATING INSTRUCTIONS

Overview
Switchung lever
Figure 1: Overview

Setting the direction of rotation:

Figure 2: Setting the direction of rotation
Setting the torque in Nm:
Unlock the handle by turning the locking screw counterclockwise. Hold the torque wrench in your hand in such a way that you
have the torque scale in view. By turning the handle, you can now set the desired torque. The scale on the shaft of the wrench
indicates the torque in Newton metres (Figure 3). For precise adjustment, use the adjustment scale on the handle (Fig. 4).
Tighten the locking screw by turning it clockwise in order to lock the handle against twisting. This prevents adjustment of the
torque during work.
Example: Adjusting the torque
Figure 3: Example setting 50 Nm
You can set the direction of rotation using the changeover lever on the top of
the torque wrench. When the lever is in the right hand position, screws can be
tightened clockwise. If it is in the left hand position, the direction of rotation is
counterclockwise.
Torque scale
Handle with an adjustment scale
Fig. 4: Example setting 56 Nm
Locking screw
7