Normal Operation - Katadyn MyBottle Mode D'emploi

Product Set-Up (Before First Use)
1. Rinse Inside of Bottle
2. Assemble the Cartridge
Attach the microfiltration cartridge to the bottom of the carbon filter. Gently twist each component
while pushing it on. Make sure ALL O-rings and components are fully sealed and assembled. Firmly
twist and push the carbon filter cartridge into the bottle cap (Figure 2).
Figure 2
3. Flush System (IMPORTANT!)
Before first use, flush system to remove harmless carbon dust. Fill bottle with water. Install bottle cap
with assembled cartridge on bottle and tighten. Squeeze bottle tightly with both hands until water
runs clear.
NOTE: Discolored water is normal when flushing.
(6)

Normal Operation

1. Fill the bottle with water to the fill line (Figure 3). Remember, the clearer the water, the longer
the microfilter and carbon filter will last.
2. Insert cartridge/bottle cap into bottle. Turn bottle cap clockwise until tight.
3. Flip open mouth piece. Note: The mouth piece has two positions. Press the mouth piece down
to close the bottle again. (Figure 4). Do not remove mouth piece.
4. Hold the bottle upright when drinking. Squeeze and sip using continuous pressure.
5. Close the mouth piece after use.
6. Do not remove the mouth piece from its fixture.
NOTE: Before each use, flush and discard small amount of water (1 squeeze) to remove stale taste.
Fill line
Figure 4
Figure 3
Open
Closed
(7)