LAZER TANGO Manuel D'utilisation page 7

INSTRUCTION - DOUBLE D BUCKLE:
TO FASTEN AND OPEN THE CHIN STRAP (FIG. 2)
1. Fasten the chin strap by passing the end of the
strap through the 2 rings as shown on picture A,
then pull it comfortably tight for a secure and
snug fit.
2. To remove the helmet pull the little red tab
outwards, the strap tension will be released as
shown on picture B. Then unthread the chin
strap.
Warning ! – The red snap placed at the end of the
chin strap must NOT be used instead of the Double
D buckle.It has been designed to avoid the chin
strap flapping in the wind at high speed.
ADJUSTING AND USING
THE MICROMETRIC BUCKLE (fig. 3)
1. First, adjust the length of the strap by rolling it
through the plastic adjustable strap (C)
2. To close the buckle, insert the ratcheted tongue
(D) into the casing (E). When you hear a "click",
the buckle is closed. The multi-notching allows
for minute adjustments in order to obtain perfect
comfort and fit with the buckle
3. If necessary, go back and repeat Step 1
4. To open the buckle, pull on the red strap (F)
and draw back the ratcheted tongue using your
other hand
HOW TO CHANGE AND REPLACE THE MAIN VISOR
Removing the screen (fig. 4):
• The screen must be in the open position (A).
• Push the fixation lever to open the central cylinder
(B) and pull the screen upwards with a short,
sharp click (C)
• Same for the right-hand side
Installing the screen:
• In open position, position the nub on the inside of
the screen into its chamber (D, E).
• Push to press the screen nubs in their chambers
(F).
• When you hear a clic, the screen is fastened.
• Repeat at the other side
Check wether the screen function correctly by
making several full openings and closings.
HOW TO USE
THE INTERNAL SUN VISOR ON YOUR HELMET
• The cursor for the internal sun screen is on the left
side of the helmet. Only use this button when your
are not riding and always with your left-hand.
• To lower the internal sun screen, lower the cursor
until it stops
• To lift the internal sun screen, lift the cursor until
it stops
Warning: never drive with the internal sun visor in
the lowered position at night or in case of poor
visibility. Always remember to raise the internal sun
visor early enough before entering a tunnel or on a
dark or shady road.
HOW TO CHANGE THE INTERNAL SUN VISOR
ON YOUR HELMET (fig.5)
• The main visor must be in the open position (A).
• The internal sun visor must be in the lowered
position (B).
• Hold the internal sun visor on one side and pull
hard to extract the visor of its fixation (C). Repeat
the operation on the other side
- 7 -