Getting Started; Canceling The Demo Mode; Setting The Clock; Detaching The Front Panel - Sony CDX-GT264MP Mode D'emploi

Getting Started

Canceling the DEMO
mode
You can cancel the demonstration display
which appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "DEMO"
appears, then press it.
3
Rotate the control dial to select
"DEMO-OFF," then press it.
The setting is complete.
4
Press (BACK).

Setting the clock

The clock uses a 24-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until "CLOCK-
ADJ" appears, then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
 –/+.
4
After setting the minute, press the
select button.
The setup is complete and the clock
starts.
To display the clock, press .

Detaching the front panel

You can detach the front panel of this unit
to prevent theft.
Press and hold  .
1
The unit is turned off.
Press the front panel release button ,
2
then pull it off towards you.
1
2
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds. The alarm will only sound if the
built-in amplifier is used.
Note
Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a
parked car or on a dashboard/rear tray.
Attaching the front panel
Engage part  of the front panel with part
 of the unit, as illustrated, and push the
left side into position until it clicks.
5