Campingaz CAMPING KITCHEN 2 CV Mode D'emploi page 7

Masquer les pouces

page de 21

/ 21
Signets

Les langues disponibles

- Camping Kitchen 2 CV : hold a flame close to the burner (Fig. 3A)

- Camping Kitchen 2 CV PZ : Wait 2 to 3 seconds and press the

corresponding piezoelectric button ( ) several times until the

burner lights (Fig. 3B). If it does not light after 3 tries, position

the adjusting knob to "OFF" (

1 minute before repeating the operation.

2) Shutting down

•

- After use, close the stove valve by putting the knob in "OFF"

position (

). Fig. 1.

D - REMOVING OR CHANGING THE CAMPINGAZ

CV 470 PLUS CARTRIDGE

The cartridge may be removed even if it is not empty. Replace

the cartridge outside and away from other people.

- Wait for the stove to cool down.

- Check that the valves on stove are fully turned off by turning

the control knobs (1) clockwise to its full extent.

- Detach the regulator (3) from the cartridge by unscrewing the

regulator (3), then lift it up (Fig. 4B).

- Push the regulator (3) onto a new cartridge and screw it

tight until you hear a click (approximately one-sixth of a turn)

(Fig. 4A). Do not force the cartridge to turn further than this or

you may risk damaging the Easy Clic

E - STORAGE - SERVICING

In case of flashbacks (ignition under the burner cap) switch the

product off, allow it to cool down (approximately five minutes),

then reignite the appliance. If the problem of flashbacks persists,

then please contact your local Campingaz

1) Stove

Ensure that your stove is regularly maintained, and it will give

you many years of excellent service.

- Do not clean the stove while it is in operation. Wait for it to

cool down, to avoid burning yourself on the hot parts (pan

Possible problems / Corrective action

Possible problems

The burner does not light up

The burner does not burn smoothly or goes out

Unstable blowing flames

Large plume of flame on the burner surface

Flame at the injector

Burning leak around a union

Insufficient heat

Burning leak behind the adjustment knob

•

) by rotating it clockwise. Wait

Plus System.

representative.

supports, burners).

- When cleaning, be careful to avoid clogging the burner holes.

If the holes are clogged, for example by food that has spilled

over, clear them with a non-metal brush.

- Clean greasy parts with soap and water or a non-abrasive

detergent.

- The pan supports (2) can be removed for cleaning purposes

by pulling them upwards.

- To reattach the pan supports, insert the legs into the holes on

each side of the burners (Fig. 5)

- Store the equipment and the cartridge in a cool, dry and

well-ventilated area, out of reach of children. Never store in a

basement or cellar.

- If the stove has not been in use for more than 30 days,check

to see if cobwebs or anything else is not clogging the burner

tube openings; this could lead to decreased burner efficiency

or to a dangerous ignition of gas outside the burner.

2) Hose connecting the regulator and the stove

- Regularly check the condition of the hose and change it if it

shows signs of wear or cracking. Please contact your local

after sales service (see separate sheet with contact details

included in the package).

- If the stove will not be used for a long period of time

disconnect the cartridge as indicated in paragraph D.

- The date which is printed on the hose is the production date

and not the expiration date. The hose can be used without

time limit as long as it is not damaged.

In case of the injector becoming clogged (the equipment will

not light although the cartridge still contains gas), do not try to

unclog it yourself. Return the equipment to your retailer.

Probable causes / Corrective action

- Poor gas supply

- Regulator not operating properly

- Pipe, valve, venturi tube or burner holes obstructed

- Check that gas is present

- Check the pipe connection