Receiving And Inspecting The Equipment; Introduction; Component Information - UniFlow UNFL9.6SHC Guide D'installation, D'utilisation Et D'entretien

RECEIVING AND INSPECTING THE EQUIPMENT

Even though most equipment is shipped crated, care should be taken during unloading so the equipment is not damaged while being
moved into the building.
1. Visually inspect the exterior of the package and skid or container. Any damage should be noted and formally reported to the delivering
carrier as soon as possible within 10 days.
2. If damaged, open and inspect the contents with the carrier.
3. In the event that the exterior is not damaged, yet upon opening, there is concealed damage to the equipment, notify the carrier.
Notification should be made verbally as well as in written form.
4. Request an inspection by the shipping company of the damaged equipment. This should be done within 10 days from receipt of the
equipment.
5. Be certain to check the compressor compartment housing and visually inspect the refrigeration package. Be sure lines are secure and base
is still intact.
6. Freight carriers can supply the necessary damage forms upon request.
7. Retain all crating material until an inspection has been made or waived.

INTRODUCTION

This user's manual is intended for installing, using and servicing your Uniflow Appliance. It is recommended that this manual be
kept in an accessible place. Every Uniflow machine is designed and manufactured according to the highest standards of safety and
performance. It meets or exceeds the safety standard of UL 471 and sanitation standard NSF 7.
Uniflow assumes no liability or responsibility of any kind for products manufactured by Uniflow, that have been altered in any way,
including the use of any parts and/or other components not specifically approved by Uniflow. Uniflow reserves the right to make
design changes and/or improvements at any time. Specifications and designs are subject to change without notice.

COMPONENT INFORMATION

ALL MODELS
COUNTER BALANCED
LID(S)
LID GASKET(S)
STORAGE
BASKET(S)
CORD SET and DRAIN OUTLET
(Located at rear of freezer)
INTERNAL DRAIN PLUG
(Bottom of storage
compartment)
AIR INTAKE
LOUVER PANEL
Page 8 of 16