Hardware Installation - Acksys AirBox V1 Série Guide D'installation Rapide

AirBox/10
AirBox/12
AirBox/14
1. Plug the antennas in
Connect the supplied antennas to the RF antennas connectors (See
connectors section).
In case of AirBox/14, don't mix up cellular antennas and WiFi antennas. WiFi
antennas have RP-SMA male connectors (with a hole at the center) whereas
cellular and GNSS antennas have SMA male connectors (with a pin at the
center).
1. Insert the SIM card (s)
The AirBox/14 is designed to accept SIM cards in Nano-SIM format (the
smallest format). Check the compatibility of your SIM card and follow these
steps:
a- Press lightly with a non-metallic pointed object with a diameter of
less than 2mm on the pin on the right side of the SIM drawer.
b- Place the Nano-SIM card in the drawer as shown below.
c- Insert the drawer in its original location in the direction indicated
below.
2. Connect the power supply
See the "specifications" section about the characteristics of the power supply.
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LEDs PWR1 and PWR2:
PWR1 LED is ON if power supply 1 is ON.
-
PWR2 LED is ON if power supply 2 is ON.
-
The Diag LED stays red for around 75 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
3. Connect the Ethernet cable
Plug the provided Ethernet cable to the LAN1 or LAN2 connector. Check that
the corresponding LAN1 or LAN2 LED turns ON at that point.

HARDWARE INSTALLATION

: WiFi (2 ant.)
: WiFi1 (2 ant.) + WiFi2 (3 ant.)
: WiFi (2 ant. ) + Cellular (2 ant.) + GNSS (1 ant.)
-2-