Hardware Installation - Acksys AirLink Guide D'installation Rapide

All manuals and user guides at all-guides.com
1. Plug the antennas in

Plug the 2 antennas of your choice into the Ant.1 and Ant.2 connectors.

For single antenna installation, use Ant.1 connector.

For dual antenna installation, use Ant.1 and Ant.2 connectors.
WARNING: It is recommended to connect a 50 ohms terminator on
unused antenna connector. If not, it may disturb radio link quality and
data throughput,
2. Connect the power supply
See the "specifications" section about the characteristics of the power supply.

The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LED Power

ON if main power supply or PoE source is ON.

The Diag LED stays red for around 60 seconds, until the device is fully ready
to use. Then the Diag LED turns green.

Use a braided grounding cable
3. Connect the Ethernet cable

Plug the Ethernet cable to the device's LAN connector.

Check that the corresponding LAN LED turns ON at that point.

HARDWARE INSTALLATION

-2-