Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Plug antenna
Connect the integrated antenna to "Main" RP-SMA connector and the
protection cap to the "Aux" connector.
a 50 Ohms load or an antenna to the "Aux" connector.
• Connect the power supply
The device can be powered up from one or two power supplies (DC 9 to 36 V
6W min.) called Power1 and Power2.
The device can also be powered via PoE (Power Over Ethernet) using the
"LAN1" RJ45 plug if the PoE function is available.
The device has no ON/OFF switch. It turns on automatically when power is
applied. Verifiy the 2 leds Power1 and Power2:
Power1 led is ON if POWER1 power supply is ON or if the device is
-
powered using PoE.
-
Power2 led is ON if POWER 2 power supply is ON.
The Diag led stays ON until the device is ready to use, usually in less than
10s.
• Connect the Ethernet cable
Plug the Ethernet cable to one of the two RJ45 connectors of the product.
The connector bottom Led lights on in yellow for a 100 Base-Tx network, or
stays unlighted for a 10 Base-T network. The top LED blinks proportionately
to the network activity.
The choice of the speed, 10 Mbps or 100Mbps, is negotiated automatically
when the link is established, according to 802.3u, but can always be
overridden by the user, with the help of the configuration interface of the
product.
SOFTWARE CONFIGURATION
• Modifying the default IP address 192.168.1.253
From any P.C of the network, run the multi-platform application ACKSYS
NDM application (found on the CD ROM).
Go directly to the next step if the default IP address is compatible with your
network.
Select the device and click on « Configure IP » button.
You can choose an IP address compatible with your network, or activate
DHCP.
• Device configuration
Click on the « Web » button to access from your web browser to the built-in
web-based interface.
You must choose the Admin user. No password is required by default.
HARDWARE INSTALLATION
For the H4 model, you must connect
-2-
Publicité
Table des Matières
