Terex Genie Z-33 Guide De L'opérateur page 11

Deuxième édition • Première impression
Panneaux de sécurité et emplacements
1261934
Tip-over Hazard
Tipping over the machine will result
in death or serious injury.
Maximum
allowable wind
speed:
28 mph /
12.5 m/sec
Maximum Capacity:
441 lbs / 200 kg
Occupants and
equipment must not
exceed
441 lbs / 200 kg
Maximum
Occupants: 2
Maximum
Allowable
Manual Force:
150 ft lbs / 667 N
28236
114390
11 9
Code d'article 1287493FRGT
114397
218559
Drive Direction Hazard
Machine can move in opposite direction of
joystick movement. Movement in an unplanned
Tip-over Hazard
direction can result in death or serious injury.
Tipping over this machine will
result in death or serious injury.
Always match the color-coded direction arrows
on platform controls and drive chassis to
Only raise the platform when the
determine direction of machine travel. Read
machine is on a firm, level
surface.
and understand operator's manual.
1262132
219487
1261934
1261934 A
Sécurité générale
219487
219 8
3
3
Tip-over Hazard
Do not overload platform.
Platform overload will result in
death or serious injury.
Crush Hazard
Contact with overhead obstructions
could result in death or serious injury.
Keep away from overhead obstructions
or other possible hazards.
218559 A
Z -33
®
Guide de l'opérateur
Platform Overload
Indicator Light
Light flashing
indicates
the platform
is overloaded.
The engine
will stop and no functions will
operate.
Remove weight from the
platform until the light goes off
and then restart the engine.
219487 A
1262132
WARNING
Driving on a Slope 1262132 A
Do not drive machine on a slope
that exceeds maximum uphill,
downhill or side slope rating.
Determine slope and side slope ratings for
and determine slope grade.
Maximum slope rating, platform
downhill (gradeability) 30% (17°)
Maximum slope rating,
platform uphill 20% (11°)
Maximum side slope rating
25% (14°)
Runaway Hazard
Note: Slope rating is subject to ground
Machine movement can occur
conditions and adequate traction. Gradeability
when machine is operated on
applies to platform downhill configuration only.
a slope that exceeds rated
Be sure boom is below horizontal
uphill, downhill or side slope
and platform is between non-steer
rating. A runaway machine
wheels.
could result in death or
Move drive speed select switch to
serious injury.
machine on incline symbol.
218559
114390
114397
28236
9