Important Recommendations - Zanussi ZER 325X Mode D'emploi

The symbol
may not be treated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste handling of
this product.
For more detailed information about recycling of this product, please contact
your local city office, your household waste disposal service or the shop
where you purchased the product.

IMPORTANT RECOMMENDATIONS

The element of such an electric fryer with a cold zone cannot operate in the
open air: it must always be dipped in oil or fat. Consequently, blocks of fat must
never be melted directly onto the element. CAUTION: IF YOU USE A SOLID
VEGETABLE OR ANIMAL FAT, IT IS ABSOLUTELY NECESSARY TO
EMPTY IT INTO THE FRYING BOWL MELTED BEFOREHAND. You thus
avoid burning out the element.
1. The level to which the bowl is filled must be between the minimum and
maximum marks engraved on the vertical side wall of the bowl for an optimal
result. You can fill till the maximum mark.
2. If you use deep-frozen foods or foods containing a lot of humidity, keep a
close eye on your fryer. When it comes into contact with water, oil boils
heavily and sometimes risks spilling over.
3. If you use fat and not oil in your fryer, it is advisable (using a knife or a fork)
to make holes in the fat before starting the fryer. That will avoid splashing if
air bubbles are caught inside. Do it delicately so as not to strike the probes
placed on the heating element
The safety thermostat is a 2nd temperature measurement. Should any
problems arise, it automatically cuts off the electric supply to the fryer. It can be
automatically restarted by hand under the housing by pushing the small red
button (Fig. 3).
on the product or on its packaging indicates that this product