B.A. International PS20X Notice D'instruction page 13

• Wipe a disinfectant wipe over each of the MD's sub-units,
• Or Spray disinfectant on the MD and wipe with a clean cloth.
Or: by Ultrasound
• Use a low frequency ultrasound tank (25 to 50 kHz) and a
detergent-disinfectant product compatible with this process and with the
MD,
D
• Friction of parts between them or with the tank can cause appearance
defects,
• Install light input/output protections on the body (Fig 7) to protect the
fronts of the fi bre optic or the emitting surface of the LED,
• Immerse the components.
Rinsing and drying
• Empty the spray pipe (Fig 4).
• Rinse well , then dry each part.
5
VI.2.2 - Automatic preparation for sterilisation
e
• Only in a washing and disinfecting machine, appropriate for the
treatment of this type of MD. Follow the manufacturer's instructions for
the device.
• If the device is not equipped with pipes for contra angles / handpieces,
then disassemble the MD (see § V.2) and immobilise each part.
Otherwise, put the MD mounted on the pipe.
• The disinfection thermo cycle must be at least 10 minutes at 93°C
(203°F).
• Check there is no residue and that all the parts of the MD are
x
completely dry at the end of the cycle.
• If the washing and disinfecting machine is near the place of use, it is
D
possible to also do step VI.1.
Re-assembly of MD:
Only assemble parts with the same serial number
• Attach the collar cartridge D to A head (only one direction possible) until
it completely plates (turn the cog until connection if required),
• Insert the head – collar cartridge unit in the G sleeve (connect a clean
tool in the head and turn it slightly so that the cog connects),
• Bring the F lever to the central position, until ratcheting. Make sure that
the depth stop system is in the right position.
E Systematically check the condition of the front part by applying axial
traction.
. . . .. . .. . .. . . .. . .. . .. . .. . . .. . .. . .. . . .. . .. . .. . .. . . .. . .. . .. . . .. . .. . .. . .. . . .. . .. . .. . . .
Temperature < 38°C, distilled water is recommended instead of running water
5
if this has too much chlorine (cf. FD98-135 standard).
6 Exception : If the After-Sales Service has to replace a part, the serial number
may be different.
EN
FR
.
6
ES
IT
DE
PO
13