WIKA A-AS-1 Mode D'emploi page 16

6. Commissioning, operation
Setting switching points and switching functions
Indication
GB
Press and hold button 1 for two seconds. The display changes to "SP1".
■
Using buttons 2 and 3, select the required switch point for switching output 1.
■
Confirm the unit set, using button 1. The display reverts to "SP1".
■
Briefly press button 1 in order to bring up the menu point "out1".
■
Using buttons 2 and 3, select the required switch function for switching output 1.
■
off = always off
no = normally open
Confirm the switch function set, using button 1. The display reverts to "out1"
■
Briefly press button 1 in order to bring up the menu point "SP2".
■
Using buttons 2 and 3, select the required switch point for switching output 2.
■
Confirm the unit set, using button 1. The display reverts to "SP2".
■
Briefly press button 1 in order to bring up the menu point "out2".
■
Using buttons 2 and 3, select the required switch function for switching output 2.
■
off = always off
no = normally open
Confirm the switching function set using button 1. The display reverts to "out2".
■
16
SP1
2 s
out1
SP2
out2
on = always on
nc = normally closed
on = always on
nc = normally closed
WIKA operating instructions attachable indicator, models A-AS-1, WUR-1
Set switching point 1
Confirm
Select switching
function 1
Confirm
Set switching point 2
Confirm
Select switching
function 2
Confirm