Rona 2009696 Manuel D'utilisation page 20

CONSIGNES D'UTILISATION OPERATING INSTRUCTIONS
Fig O
OPERATION
NOTE: The edger is a major appliance and
should not be operated simultaneously with
other major appliances on the same household
electrical circuit.
Make sure that other persons and pets are
at least 100 feet away.
EDGING
1. Set cut depth at 1" and set edge guide
to the EDGING position, refer to Assembly
Instructions.
2. Before starting the edger, line up the tool so
the edge guide rests against the edge of the
paved surface (See Fig. P). Both rear wheels
should be on the paved surface when edging.
Fig P
A
20
3. To avoid kickback of edger, tilt the handle down
so the blade is above the ground (See Fig Q).
4. Turn switch ON and allow blade to spin
without moving tool.
5. Slowly lift the handle to lower the blade,
finding the edge of the paved surface and start
edging. Then move tool forward slowly along
edge of paved surface, keeping the edge guide
pressed lightly against the pavement edge.
move forward slowly because grass is thickest
then. Subsequent edging will be completed
more rapidly. If the tool slows down, back it
up an inch or two until the blade comes up to
normal speed. During edging some sparks
may be generated from hitting stones. This is
normal. Do not attempt to edge when the grass
or soil is wet or moist—for electrical safety and
to prevent clogging of the blade chamber. If
you must edge under conditions that cause the
blade chamber to become clogged, release
switch lever, wait for blade to come to complete
stop! UNPLUG TOOL! open door and remove
clogged material with a stick. To continue to
operate the tool in a clogged condition will
seriously overload the motor.
CAUTION: Do not attempt to unclog the blade
chamber by dropping or tapping the tool on the
ground.
This can damage the unit. Keep hands clear of
edge guide and blade when cleaning as these
wear to a very sharp point during edging.
LANDSCAPING/TRENCHING
Before landscaping or trenching, inspect and
Fig Q
ensure there are no exposed or buried cables,
pipes or other objects that may create a hazard
or interfere with operating the edger. Set depth
to only that required for the job.
Do not overload. If tool slows down, pull back
slightly and wait until blade comes up to normal
speed.
For the first edging each season, it is best to