Rona 2009696 Manuel D'utilisation page 19

OPERATING INSTRUCTIONS
Fig K
Fig L
Fig M
BLADE (fIGURE N)
Wait for blade to come to complete stop!
UNPLUG TOOL!
Please check that the blade has been properly
mounted before using your edger. The blade
has two wear indicators that show when blade
needs to be replaced. When the blade wears
to the small hole at each end of the blade it will
give only 6.35mm depth of cut and should be
replaced.
Tip: To increase blade life, keep initial
cutting depth at minimum and increase
depth setting as blade wears.
Fig N
TO REMOVE THE BLADE fOR
REPLACEMENT:
Wait for blade to come to complete stop!
UNPLUG TOOL!
9
Blade rotates momentarily after the switch is
released.
1. Open the guard.
2. Loosen the hex head nut (9/16"). Use a 1''
wrench on the outer spacer, or a 50.8mm x
101.6mm wood block between the blade and
guard if necessary to hold the blade from
turning.
TO ATTACH NEW BLADE:
3. Ensure inner spacer is on shaft—"flats" in
spacer hole must engage with "flats" on shaft.
4. Holding the spacer in place, put the blade
on the shaft.
5. Hold the blade against the spacer and install
the outer spacer, again aligning the flats in the
spacer with the flats on the shaft.
6. Install the hex head nut, then tighten with a
wrench.
Note: Replace hex head nut and conical
washer only with identical replacement part,
see Service Information.
7. Close blade guard; knob must be in locking
position.
SWITCH (SEE fIG. O)
To turn the tool on, depress the lock-off button
and then squeeze the switch lever. To turn the
tool off, release the switch lever.
A
19