Assembling The Handle - Rona 2009696 Manuel D'utilisation

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
MOUNTING

ASSEMBLING THE HANDLE

1. Remove knob and curved head bolt from
tube mounting holes.
2. Slide the handle into the end of the upper
tube so that holes will line up, then fasten
handle tubes together with the knob. (See Fig.
A, B)
Fig A
Fig B
3. Slide upper handle tube down into lower
handle tube so that holes will line up. There
are two positions available for adjustment to
your preferred height setting. (See Fig. C)
Fig C
4. NOTE: Ensure the wire cable moves
smoothly down into the lower handle tube
while assembling.
5. Fasten handle tubes together with the knob
and curved head bolt. Note that when you first
insert the bolt, it may be necessary to wiggle it
carefully to get it past the jacketed wire inside
the tube. (See Fig. D)
Fig D
NEVER use a sharp object to move jacketed
wires out of the way.
CUT DEPTH ADJUSTMENT
The front wheel can be adjusted to allow a
deeper or shallower cut, and to increase the
life of the blade. To change the cut depth from
the shipping position to your desired depth:
1. Wait for blade to come to complete stop!
2. Unplug tool!
3. Open the cut depth knob. (See Fig. E, F)
Fig E
Fig F
A
17