Mounting The Exhaust Air Socket - Rohde ELS-N Manuel D'utilisation Original

Step Description
6 Screw in the bolt = the ELS kiln floor rises.
7 Unscrew the bolt = the ELS kiln floor lowers.
8 Tighten the locknut of the adjusting screw again.
⇒ Hold the screw with a second tool so that it does not
twist again, and the setting is lost.
9 Tighten the bolts of the bearing on the lower guide roller.
Carry out the setting for the other bearing of the second guide
10
roller.
11 Check the setting of both guide rollers with the spirit level.
Check the extension and retraction of the kiln floor.
⇒
12 The kiln floor should move smoothly and without
great effort.
Table 14: Setting the inclination angle of the kiln floor
6.2.6.

Mounting the exhaust air socket

Figure 6: Exhaust air socket
Remark
Tool:
Only adjust the kiln floor in small steps
and check the setting several times with
the spirit level.
Tool:
Only adjust the kiln floor in small steps
and check the setting several times with
the spirit level.
Tool:
Spanner
Tool:
Tool:
Spirit level
Mount the exhaust air socket above the exhaust air flap on top of
the kiln.
The fastening material is included in the kiln's scope of delivery.
It is also possible to mount an exhaust air hose on the exhaust air
socket and to divert escaping vapours and gases into an exhaust
air system.
93 / 492 - EN -
• Spanner
• Spirit level
• Spanner
• Spirit level
• Spanner or socket wrench
• Allen key