Installation and Operating Instructions
Electrical preheater – KWL-EVH 360 W
– Remove silencer
1.
Slide connecting pipe towards the top of the unit (see Fig. 4).
2.
Swing out the bottom of the silencer and remove the silencer downwards from the unit (see Fig. 5).
4. Remove rubber seal for cable gland, so that the cable gland is open (see Fig. 6 and 7). Keep rubber seal.
5. Insert preheater with grille upwards into the intake air shaft (see Fig. 8).
6. Lead the preheater cable with the rubber seal through the cable gland (see Fig. 9).
Fig .4
Fig .6
Fig .8
4
EN
Fig .5
Support rail
Fig .7
Fig .9