Important - BaBylissPro 4ARTISTS DIGICURL F95a Mode D'emploi

Hair type des-
cription
Damaged
Coloured
Thin
Medium
Thick
Wavy, coarse
HOW TO USE THE DIGICURL
WANDS
CAUTION! Do not place the ap-
pliance on any heat sensitive sur-
face whilst in operation. Use the
heat mat and stand provided to
protect the work surface whilst
styling the hair.
• Press the button marked I/0 to
switch the wand on. The tempe-
rature display panel will begin to
flash 160°C.
• The wand will automatically ad-
just to the 160°C temperature
setting each time it is switched
on and this will be displayed on
the LCD screen.
IMPORTANT: Within 4 seconds of
turning the appliance on, the tem-
perature setting will automatical-
ly lock. You are able to adjust the
temperature setting immediately
after switching on the iron, howe-
ver if the temperature locks, hold
down either the +/- buttons for
1-2 seconds to change the tem-
perature.
• The temperature increases in 5°C
increments for specific tempera-
ture control (160°C – 210°C).
Recommended tem-
perature setting
160°C - 165°C
165°C - 170°C
170°C - 175°C
175°C - 185°C
190°C - 200°C
200°C - 210°C
NOTE: Always start with a lower
temperature setting and increase
gradually if required.
• The temperature on the display
will flash while the iron is heating
up to the selected temperature.
You may still change the tempe-
rature setting at this time.
• When the selected temperature
has been reached, the tempera-
ture display will stop flashing.
WARNING!
reaches up to 210°C, please take
care to avoid the hot surface of the
barrel coming in to direct contact
with the skin, in particular the ears,
eyes, face and neck.
STYLING ADVICE
• Ensure hair is dry and combed
through. Before styling make
sure the heat protection glove is
worn on the hand which is wrap-
ping the hair around the barrel.
• Take a section of hair starting
around 2 inches from the scalp.
• Hold the iron at a slight angle
pointing the cool tip downwards.
• Wind the hair in a spiral motion.
As you wind the hair around the
barrel, ensure the hair is distribu-
ted evenly so the entire section
is touching the barrel. Try not to
overlap the hair as you wrap.
• Hold in place for 5-8 seconds
depending on the texture and
length of the hair.
• To remove the iron from the hair,
let go of the end of the hair sec-
tion and pull the iron away.
• Allow the curl to cool before sty-
7
This appliance