Led Indicator - AutoAqua Smart ATO micro SATO-120P Mode D'emploi

Installation
1. Mount the optical level sensor on the tank/sump.
2. Plug the siphon break into the tubes, keep it higher than the water
level of the reservoir, and set up the water tube by the universal holder.
3. Connect both of the DC pump and power adapter with the controller
and then connect power.
Air In
Water Out
PUMP POWER
Power

LED Indicator

LED Color
Light on
Blue LED
Flashing
*
Red LED Flashing with audible alert
* Please check the tank/sump and then reset (unplug and replug power cable)
Siphon break must be higher than the
water level in the reservoir.
Air In :
break the siphon when the pump turns off.
Water Out :
Direction
are normal when the pump is on.
Optical Level Sensor
Tank/Sump
Status
Siphon break allows air in to
Water drops out of the hole
DC Refill Pump
Reservoir
Meaning
Power on
Refilling / Pumping
1.Empty Reservoir
2.Bubble noise
English
2