Lega 8230 Guide D'instructions page 46

Install the two shelves (one at the bottom and one mid-height) and fill the cabinet with jars so that most of
them is in contact with the surrounding air. For this reason, avoid stacking jars too close together.
Alternatively, it is possible to place two 25 kg cans inside the cabinet.
Power on via the main switch located on the control panel (fig. 3 - item 2).
The cabinet is factory-set not to exceed a temperature of approximately 45°C.
THE MAXIMUM TEMPERATURE WHICH CAN BE REACHED BY THE CABINET IS 70℃.
The first displayed temperature value shows the temperature inside the cabinet upon power-on;
subsequently, the pre-set value of the maximum temperature which can be reached is displayed.
To change this temperature setting, press the SET (C) control and hold it for about 3 seconds; then press the
button with the arrow pointing up (A) to increase the temperature degrees or the button with the arrow pointing
down (B) to decrease them.
Never exceed a temperature of approximately 40-45°C
Caution: It is advisable to allow your new equipment to run empty for a few hours, to prevent any first-use
smells from contaminating the product.
23. OPERATION INSTRUCTIONS –
The pollen drier cabinet comes equipped with 10 extractable drawers with stainless steel mesh and frame.
These drawers have an air intake on one side to help hot air forced circulation through the various drawers,
starting from the bottom all the way to the top and leaving through the top wall.
The drawers containing the pollen to dry must be introduced in their special guides, checking that there are
alternately one air intake on the rear wall and one on the front wall, to ensure that air flows to the top in a
crisscross pattern going homogenously through all the drawers.
Lay pollen homogeneously in the 10 drawers and insert the drawers in their special guides.
Power on via the main switch located on the control panel ((fig. 3 - item 2)
The cabinet is factory-set not to exceed a temperature of approximately 45°C.
THE MAXIMUM TEMPERATURE WHICH CAN BE REACHED BY THE CABINET IS 70°C.
The first displayed temperature value shows the temperature inside the cabinet upon power -on;
subsequently, the pre-set value of the maximum temperature which can be reached is displayed.
To change this temperature setting, press the SET (C) control and hold it for about 3 seconds; then press the
button with the arrow pointing up (A) to increase the temperature degrees or the button with the arrow pointing
down (B) to decrease them.
Never exceed a temperature of approximately 40-45°C.
Caution: It is advisable to allow your new equipment to run empty for a few hours, to prevent any first-use
smells from contaminating the product.
24. MAINTENANCE INSTRUCTIONS
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
Drier Cabinet (item 8230)
46 / 56