Lega 8230 Guide D'instructions page 45

20. POSITIONING
After removing the equipment from its packaging, place it on a firm, flat and stable floor and proceed by
slowly peeling off the white protective plastic film.
The cabinet must then be precision-levelled by adjusting its feet using a spirit level. The support feet can be
height-adjusted by turning.
Position the cabinet making sure that the cooling slots located on the front side, below the control panel, are
not covered.
21. START-UP
All the HTAC line models are pre-set for 120 V AC - 50/60Hz power input.
The Cabinets described in this manual come equipped with a plug suitable for power line connection.
Before starting up, check that:
the line voltage matches the voltage specified on the equipment data plate (Fig. 1); in order to guarantee
smooth operation, the input voltage must be within a range of ±6% of the rated value;
the electrical system to which the cabinet must be connected is suitably sized according to the rated
electric power to install;
the electrical system to which the cabinet must be connected is built to comply with the applicable
standards in force;
All the models described in this manual are equipped with an equipotential terminal designed to allow several
cabinets belonging to one bank to be connected together, using a standard grounding wire (Fig. 4).
The terminal strip is located in the rear part of the Honey Liquifier, as is the equipotential terminal.
CAUTION! The manufacturer may not be held responsible for any damages caused by poor or
inefficient grounding, wrong installation, tampering, poor maintenance or inexperienced use of the system.
22. OPERATION INSTRUCTIONS –
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
Honey Liquifier Cabinet (item 6705)
45 / 56