Table des Matières
Publicité
TFA_No_35.1079_Anleitung.bel 13.05.2007 14:49 Uhr Seite 12 (Schwarz/Process Black Bogen)
AXIS
– Wireless weather station
Please take note of the following:
•
Recommended distance to any interfering sources like computer
monitors or TV sets is a minimum of 1.5 - 2 metres.
•
Within ferro-concrete rooms (basements, superstructures), the re-
ceived signal is naturally weakened. In extreme cases, please place
the unit close to a window and/or point its front or back towards
the Frankfurt transmitter.
•
During night-time, the atmospheric disturbances are usually less
severe and reception is possible in most cases. A single daily recep-
tion is adequate to keep the accuracy deviation below 1 second.
•
The clock automatically scans the time signal at 2.00 a.m., 8.00 a.m.,
2.00 p.m. and 8 p.m. everyday to maintain accurate timing. If the
reception is not successful, the DCF reception symbol disappears,
but the DCF time reception will be repeated again. The manually
set time will be overwritten by the DCF time when the signal is
received successfully.
3.3 Additional transmitters
•
The wireless weather station can receive up to 3 temperature sen-
sors. If you have purchased additional remote sensors, repeat step
1) for all extra sensors. However, ensure that you leave 10 seconds
in between the reception of the last sensor and the set-up of the
following sensor. The wireless weather station will number the
sensors in the order of set-up automatically.
4. How to operate
•
The base station has three sections on the LCD: Time Mode, Indoor
Temperature & Humidity Mode and Outdoor temperature mode.
Press "SET/MODE" key to change between the sections (arrow).
•
Press the "+/CH" key in time mode to select the display of time,
calendar(day-month-year) and alarm time.
•
In outdoor temperature mode press "+/CH" key to toggle bet-
ween the outdoor sensor 1,2,3 ( If more than 1 sensor is used )
•
During operation, all successful settings will be confirmed by an
acoustical signal.
•
The instrument will quit the setting mode, if there is no button
used within 30 seconds.
4.1 Setting Mode
•
Press the "SET/MODE" key for 3 seconds while in normal mode to
enter the normal setting mode.
•
In the setting modes, press "+/CH" key or "-/MIN/MAX" key to
select the units or scroll the value. Holding the keys will increase/
decrease digits in great steps.
•
Press the "SET/MODE" key to select the following setting in
sequence :
1. Time Zone Setting +-12 hrs.: The time zone is used for countries
where the DCF signal can be received but the time zone is
different from the German time (e.g. + 1=one hour later).
12
AXIS
– Radiografisch weerstation
•
Het apparaat is niet geschikt voor medische doeleinden of voor
openbare informatie, maar bestemd voor particulier gebruik.
•
Onvakkundige behandeling of niet geautoriseerd openen van het
apparaat heft het verlies van de garantie tot gevolg.
•
Deze gebruiksaanwijzing of gedeelten eruit mogen alleen met
toestemming van TFA Dostmann worden gepubliceerd.
Hiermee verklaren wij, dat deze radiografische
installatie voldoet aan de belangrijkste eisen
van de R&TTE richtlijn 1999/5/EG.
TFA Dostmann GmbH & Co. KG, D-97877 Wertheim
37
Publicité
Table des Matières
