Auxiliary Input Socket; Headphone Socket - Sangean RCR-24 Mode D'emploi

Setting tuning step
4. After the FM range setting is completed, FM tuning step setting will flash on the display (e.g. FM
100). Press the Tuning up/down button to select the desired FM tuning step (50 kHz or 100 kHz)
and press the Source button to confirm the setting.
5. After the confirmation of the FM tuning step, press the Tuning up/ down button to select the desired
AM tuning step (9 kHz or 10 kHz) and press the Source button to confirm the setting. (North America
use 10 kHz)
Note:
Change in the AM tuning step setting will result in the removal of AM presets stored in the radio, but
is not the case for FM tuning step reset.
Time format
6. After the tuning step setting is completed, the display will switch to the Time format setting (i.e. 24H
or 12H). Press the Tuning up/down button to select the desired time format and press the Source
button to confirm the setting.

Auxiliary input socket

A 3.5mm stereo Auxiliary Input socket is provided on the rear of your radio to permit an audio signal
to be fed into the unit from an external audio device such as iPod, MP3 or CD player.
. Repeatedly press and release the Source button until "AUX" is shown.
2. Connect an external audio source (for example, iPod, MP3 or CD player) to the Auxiliary Input socket.
3. Adjust the volume setting on your iPod, MP3 or CD player to ensure an adequate signal level from
the player, and then press the Volume up/ down button on the radio as needed for comfortable
listening.

Headphone socket

A 3.5mm headphone socket located on the rear of your radio is provided for use with either
headphones or an ear buds.
Inserting Headphones or ear buds will automatically mute the internal speakers.
Warning:
Excessive sound levels from ear buds and headphones can cause hearing loss. Always listen at
reasonable levels to avoid hearing loss.
0