Diamond Blades - Husqvarna K 535i Manuel D'utilisation

CAUTION: Cutting with abrasive blade is not
allowed with the Vac attachment. Use of
abrasive blades causes unnatural wear on
the Vac attachment.
CAUTION: Do not use abrasive blades with
thickess exceeding maximum recommended
thickness, refer to
22
• Do not use worn reinforced wheels from larger
power tools. Wheels intended for a larger power tool
are not suitable for the higher speed of a smaller tool
and may burst.
• The cutting material on abrasive blades consists of a
grit bonded agent using an organic binder.
Reinforced blades are made up of a fabric or fibre
base that prevents total breakage at maximum
working speed if the blade should be cracked or
damaged.
• A cutting blade's performance is determined by the
type and size of abrasive corn, and the type and
hardness of the bonding agent.
• Ensure the cutting blade is not cracked or damaged.
• Test the abrasive blade by hanging it on your finger
and tapping it lightly with a screwdriver or the like. If
the blade does not produce a resonant, ringing
sound it is damaged.
• Ensure that correct abrasive blade is used on the
intended material.
745 - 008 - 12.11.2018
Technical data on page
xxxx

Diamond blades

WARNING: Never use a diamond blade to
cut plastic material. The heat produced
during cutting may melt the plastic and it can
stick to the cutting blade and cause a
kickback.
WARNING: Diamond blades become very
hot when used. An overheated blade is a
result of improper use, and may cause
deformation of the blade, resulting in
damage and injuries.
Note: Sharpen the blade by cutting soft material such as
sandstone or block.
• Always use a sharp diamond blade.
• Diamond blades can become dull when the wrong
feeding pressure is used or when cutting certain
materials such as heavily reinforced concrete.
Working with a dull diamond blade causes
overheating, which can result in the diamond
segments coming loose.
• Diamond blades consist of a steel core provided with
segments that contain industrial diamonds.
• Diamond blades are ideal for masonry, concrete and
other composite materials.
• When using diamond blade make sure that it rotates
in the direction indicated by the arrow on the blade.
Wet cutting
CAUTION: Do not use Vac equipment
together with the wet system.
• Diamond blades for wet cutting must be used with
the wet system.
• Water cool the blade and increases its service life
while also decrease the dust.
• When wet cutting, make sure to collect the waste
water safely.
11