Assembly; Abrasive Blades - Husqvarna K 535i Manuel D'utilisation

Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
Applicable cutting blades
Cutting blades for Husqvarna K 535i are available in two
basic models: abrasive blades and diamond blades.
Cutting blades for handheld high
speed power cutters
WARNING: Only use diamond blades and
abrasive blades for concrete. Do not use
blades with serrations such as circular wood
cutting blades or blades with carbide tips.
The risk of kickback is increased and
carbide tips can come off and be thrown at
high speed. This can result in injury or
death.
WARNING: Incorrect use can cause the
blade to become too hot. A blade that is too
hot can cause malfunction, which can cause
damage and injury.
WARNING: Do not use a cutting blade with
a lower maximum speed than that of the
power cutter. Only use cutting blades that
10
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.

Assembly

Note: Only cut materials approved in the instruction
supplied with the blade.
Check that the blade is approved for the same or higher
speed written on the type plate of the power cutter.
Blade vibration

Abrasive blades

are in compliance with national or regional
standards.
100 m/s
XXXX rpm
CAUTION: If you use the product with too
much force, the blade can get too hot, bend
and cause vibrations. Use the product with
less force. If the vibrations continues,
replace the blade.
WARNING: Do not use abrasive blades with
water. The strength is impaired when
abrasive blades are exposed to water or
moisture, which results in an increased risk
of the blade breaking.
745 - 008 - 12.11.2018