Frequently Asked Questions - Greenway GWD4650W Guide D'utilisation Et D'entretien

ATTENTION:
Do not return this product to the store. For questions on operation, assembly
or parts, please contact us at www.greenwayhp.com or 1-866-253-0447.

FREQUENTLY ASKED QUESTIONS

Q: Why is my water dispenser leaking?
A: f you are experiencing a leak with your water dispenser please do the following to see if the
water bottle or the dispenser is leaking.
1. Unplug the unit, turn off all power switches and remove the bottle.
2. Remove the bottle support collar and check the water level inside the reservoir – it should be at
roughly three-quarters full. Water level should be approximately 3/4" – 1" BELOW VENT TUBE.
3. Let water sit for 2 hours. If the dispenser does not leak, it is the bottle that is leaking due to
a small crack or pinhole and it needs to be replaced. If the dispenser is leaking, please contact
Greenway Home Products at support@greenwayhp.com or 1-866-253-0447.
IMPORTANT: To avoid water overflow while cleaning the dispenser, always remove the bottle
support collar before pouring water or cleaning solution into the reservoir. (See Figure A, page 3).
Q: Why do I get a plastic taste from my dispenser?
A: As with most new appliances such as coffee makers and kettles, there is often a plastic taste upon
initial start-up of the unit. To remove this taste, simply follow the cleaning instructions outlined in
Cleaning the Reservoirs.
Q: What do the ready-to-dispense indicator lights mean?
A: When illuminated, they mean the following:
Red: "flashing"
"on"
Blue: "on"
Q: What is the spike that goes into the bottle?
A: Greenway ® water dispensers feature a "piercing valve" as part of the bottle support collar, providing
added convenience for water bottle installation. Depending on the water bottle supplier, a small
opening may or may not be present in the bottle cap for this specific purpose. If the piercing valve
opening is not present, the entire bottle cap must then be removed to eliminate possible damage to
the piercing valve. If the opening is present, remove the protective seal prior to installing the bottle.
8
Heater is in operation
The hot water has reached its optimum
temperature and is ready for dispensing
The cold water has reached its optimum
temperature and is ready for dispensing