Troubleshooting Tips - Greenway GWD4650W Guide D'utilisation Et D'entretien

SPECIFICATIONS
Output per hr:
Internal Tank:
Heating Temp (approx.):
Cooling Temp (approx.):
Power Consumption:

TROUBLESHOOTING TIPS

Problem
Water dispenser is leaking
Water is not hot or
cold enough
Water Dispenser
is not dispensing water
Water dispenser is noisy
GWD4650W
Hot 1.3 gal / 5.0 L
Cold 0.5 gal / 2.0 L
Hot 0.16 gal / 0.6 L
Cold 1.0 gal / 3.9 L
194°F / 90°C
46°F / 8°C
Hot 1300 W
Cold 80 W
Possible Cause
Small pin hole or crack in the bottle,
(common with recycled water bottles).
Drain cap and silicone seal are not secure.
Water was poured directly into bottle
support collar and overflowed.
All the water in the tanks have been used.
The unit is unplugged.
EZ-heat was not activated.
The circuit breaker in your home is
tripped or the fuse has blown.
Cold water power switch is not turned
on at back of unit.
Temperature limit tripped.
Thermostat needs to be adjusted colder.
Empty water bottle.
Mineral deposits clogging tanks.
Possible air pocket.
Bottle making a gurgling noise as it
fills the tank.
Water dispenser is uneven.
WARNING: The Water Dispenser
heats and dispenses water to
194˚ F / 90˚ C which can cause
severe burns or scalding.
DO NOT ALLOW CHILDREN TO USE
THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND
DIRECT SUPERVISION.
Suggested Solution
Install a new bottle of water.
Ensure seal is secure in drain plug and
tighten drain cap.
Drain by pressing dispenser buttons.
Replace with full bottle and wait 30
minutes for the water to cool.
Plug it into the outlet.
Activate EZ-heat by pressing the button.
Reset the breaker or replace the fuse.
Turn switch to the ON position.
Set all power switches to OFF position,
wait 5 minutes, then set all power
switches to the ON position. Wait 30
minutes for the water to heat or cool.
Adjust thermostat between min (cool)
and max (colder) levels to achieve
desired temperature.
Replace with full bottle.
See Cleaning the Reservoirs.
Push down on the dispenser buttons to
prime the unit.
This is normal.
Make sure the dispenser is on an even
surface that can support its full weight.
Childproof
safety
switch
7