Rear Panel - Viscount Cantorum VI Plus Mode D'emploi

User Manual

2.2 REAR PANEL

1. [POWER ON] switch: switches the Cantorum VI Plus on and off.
2. [AC INPUT] socket: connector for the power cable supplied with the instrument.
3. [MIDI] connectors: connectors for connecting MIDI devices.
-
[IN]: input connector for receiving data from an external MIDI unit to the Cantorum VI Plus.
Connect to the MIDI output of the transmitting device (e. g. a sequencer).
-
[OUT]: this connector transmits the MIDI data generated by Cantorum VI Plus. Connect to
the MIDI input of the receiving device (e. g. an expander).
4. [PEDAL] connectors: connectors for connecting pedals.
-
[EXPR]: connector for the expression pedal, to continuously control the instrument volume.
-
[SUSTAIN]: connector for a switch-type pedal to control the Sustain effect for orchestral
voices.
N.B.
When switching on, the instrument automatically detects the polarity of the switch pedal
connected to the [SUSTAIN] connector. Do not hold down the pedal when turning the power on,
to avoid reversing the operation of the pedal.
5. [USB] connectors:
-
[ ]: insert the USB stick you want to use into this connector.
-
[TO HOST]: connector for transmitting and receiving MIDI data with a computer.
N.B.
Always use USB stick formatted with FAT or FAT32 file system (no NTFS).
6. [OUT] connectors: line outputs for connection to external audio devices (powered speakers, mixers,
amplifiers), in which the instrument's general signal is present.
In case of stereo system, connect the [L/Mono] output to the left channel and the [RIGHT] output to
the right channel. If a monophonic system is used, only connect the [L/Mono] connector.
1 2 3 4 5
EN - 6
6 7