Product Data Sheet - Kitchenaid 2200139A Guide D'utilisation Et D'entretien

Product Data Sheet

Water Filtration System Model WF-L500
This product has been tested and certified by NSF International under ANSI/NSF Standard 42 for
Chlorine reduction (Class I), Taste and Odor reduction and to Standard 53 for Lead reduction.
Specifications:
Average
General
Influent
Performance
Chlorine 2.0 mg/L
Contaminant U.S. EPA
Reduction MCL
††
Performance
Lead @ pH 6.5 0.015 mg/L
Lead @ pH 8.5 0.015 mg/L
† Test requirement is 0.15 mg/L ± 10%
††
These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
®
NSF is a registered trademark of NSF International
32
Lead and Taste/Odor/Chlorine reduction (Class I) capacity
500 Gallons (1893 Liters)
Service Flow Rate 0.5 GPM (1.89 L/min) @ 60 psi
Maximum Average
Effluent Effluent
N/A
0.1 mg/L
Average Maximum
Influent Effluent
†
†
0.16 mg/L 0.007 mg/L
†
†
0.14 mg/L 0.012 mg/L
Minimum %
Reduction
N/A
Average Minimum %
Effluent Reduction
0.004 mg/L 95%
0.008 mg/L 91%
Application Guidelines/
Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
• It is essential that operational, maintenance, and filter
replacement requirements be carried out for this
product to perform as advertised.
• The filter monitor system measures the amount of
water that passes through the filter and alerts you to
replace the filter. When 90% of the filter's rated life is
used, the filter indicator light changes from green to
yellow. When 100% of the filter's rated life is used,
the filter indicator light changes from yellow to red,
and it is recommended that you replace the filter. Use
replacement cartridge part #L500 or #4392857.
1998 suggested retail price of $29.95 U.S.A/$39.95
Canada.
• The product is for cold water use only.
• Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system.
Average % NSF Test
Reduction Requirement
93% minimum 75% reduction
(Class I)
NSF Test Requirement
Average %
Reduction
97% maximum effluent 0.015 mg/L
maximum effluent 0.015 mg/L
94%
City or Well
30-120 psi (207-827 kPa)
33 ˚ -100 ˚ F (0 .6 ˚ -37.8 ˚ C)