Connecting External Components; Installing The Dab Antenna - Kenwood KDC-BT730DAB Mode D'emploi

INSTALLATION/CONNECTION

Connecting external components

Output terminals
When connecting to an external amplifier, connect its ground wire to the car's chassis to
avoid damaging the unit.
Front/Subwoofer output
For 3-way crossover: Mid Range/Woofer output
34 ENGLISH
Microphone input jack (page 14)

Installing the DAB antenna

Connect the supplied DAB antenna to the DAB antenna jack. (Page 33)
Caution
• The film antenna (F) is exclusively for use inside the vehicle.
• Do not install at the following locations:
– where it may block the driver's view.
– where it may obstruct the operation of safety devices such as air bags.
– on movable glass surfaces such as the rear hatch.
– at side of vehicle (e.g. door, front quarter window).
– on rear window.
• Signal strength will weaken when installed at the following locations:
– on IR reflecting glass or locations covered with mirror type glass film.
– where it overlaps with genuine radio antenna (pattern).
– where it overlaps with window heating wires.
– on glass that blocks radio signals (e.g. IR reflecting glass, thermal insulation glass).
• Poor reception may occur:
– due to noise when windscreen wiper, air conditioner, or motor is turned on.
– depending on the direction of the broadcast station with respect to the vehicle (antenna).
• Thoroughly wipe oil and dirt from the pasting surface with the supplied cleaner (I).
• Do not bend or damage the film antenna (F).
• It may not be possible to install on certain vehicles.
• Check the cable routing of the film antenna (F) and amplifier unit (G) before pasting.
• Do not apply any glass cleaner after pasting the film antenna (F).