Basic Procedure; Removing The Unit - Kenwood KDC-BT730DAB Mode D'emploi

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate (×1) (B) Trim plate (×1)
(C) Mounting sleeve (×1) (D) Wiring harness (×1)
(E) Extraction key (×2)

Basic procedure

1 Remove the key from the ignition switch, then disconnect
the terminal of the car battery.
2 Install the DAB antenna.
See "Installing the DAB antenna" on page 34.
3 Connect the wires properly.
See "Wiring connection" on page 33.
4 Install the unit to your car.
See the following "Installing the unit (in-dash mounting)".
5 Connect the terminal of the car battery.
6 Press B SRC to turn on the power.
7 Detach the faceplate and reset the unit within 5 seconds.
(Page 3)
32 ENGLISH
Installing the unit (in-dash mounting)
Orientate the trim
plate as illustrated
before fitting.

Removing the unit

1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the holes on both sides of the trim plate, then pull it out.
3 Insert the extraction keys deeply into the slots on each side, then follow the arrows as shown on the
illustration.
Do the required wiring.
(Page 33)
Hook on the top side
Bend the appropriate tabs to hold the
sleeve firmly in place.
Dashboard of
your car