Laserworld Club Série Mode D'emploi page 11

Manual: Club Series MKII
ILDA control: Connect your device („ILDA IN") via an ILDA cable to an interface / con-
troller. Use a laser control software, to run the device. Use „ILDA OUT" to connect it to
another device. In ILDA mode all DIP switches should be switched o .
Master-Slave-Mode: To use the daisy chain / Master-Slave-Mode connect two (or more)
laser projectors of the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
Master projector
Choose stand-alone
or sound-to-light-
mode at the master
projector
(see above)
6. To turn o the device switch it o („OFF"), switch the key to „OFF" and disconnect the
power cable from the mains.
page 11 / 33
DMX cable Slave projector
DMX setting at the
slave projector: