Maintenance And Cleaning - Indexa DF110 Mode D'emploi

120TX until the connection LED [10] on the transmitter flashes. When
wireless connection is sucessfully established the following message will
appear on the display monitor: "Pairing OK save data". This message will
disappear after approx. 10 seconds and the picture from the AV-source will
appear. The connection LEDs [10 and 21] will illuminate green.
11. Wireless range
The wireless range is dependent on many factors. In an ideal location and by
free line of sight (between both antennas) a range of up to over 100 m can
be possible, within buildings this is reduced to a maximum of up to 20 m.
The range cannot be guaranteed as it is dependent on the local conditions.
A reduction of the range will be caused by:
#
Walls and Floors, in particular those of metal or with metal reinforcement
#
Coated windows (eg. those with Insulating glass), radiators, mirrors and
other metal surfaces
#
Electrical cables and electrical products (eg. electrical motors, microwave
ovens)
#
Devices using the same or similar frequency (eg. WiFi-systems)
12. Linking of two sets (repeater function)
!
If two sets are linked to extend the wireless range between another
wireless device these should be connected and located as described in
chapter 7. The receiver and transmitter which are connected by cable
should be placed minimum 1m apart to avoid interference.
!
To connect the devices together, connect the audio input [6] of the
transmitter to the audio-output [17] of the receiver and the video input [8]
of the transmitter to the video output [20] of the receiver using the adapter
[19]. The connection cables can be max 100 m using RG 59/75 Ohm
cable.
!
During the pairing procedure it is necessary to connect a video monitor, TV-
set or a PC to the receiver "in the middle".
!
The symbols for both wireless connections will be shown superimposed on
the screen.
!
In the repeater mode the pictures are compressed twice. The picture rate is
reduced and the time lapse increased.

13. Maintenance and cleaning

#
The products are maintenance-free: do not open the housings
#
Check the safety and function regularly
#
Remove the mains adapters from the mains sockets before cleaning
#
Use a soft, slightly moist cloth or brush to clean the surfaces
14. Optional Accessories
#
Antenna extension cable with wallbracket for displaced installation of
antenna
length 2 m, absorption 1,6 dB, Art. Nr. 27 243
length 4 m, absorption 3,2 dB, Art. Nr. 27 244
15. Disposal
Do not dispose of packaging material, used batteries or products as
household waste. Please use your recycling system. Details are
available from your local authority.
16. Declaration of conformity
Indexa GmbH , Paul-Böhringer-Str. 3, D- 74229 Oedheim declares that this
product complies with the basic requirements and the other relevant
regulations of Directive 1999/5/EC. Conformity has been demonstrated. The
complete declaration of conformity can be read at: www.indexa.de
This product can be used in the following countries:
D A L CH
17. Warranty
For private consumers the product is warrantied against defects for 2 years
from the date of purchase. Please keep your receipt as proof of purchase.
The warranty only covers material or manufacturing defects. It does not cover
NL B IRL GB
GB - 21