Indexa DF110 Mode D'emploi page 20

re ception quality can be reduced. Locate the devices away from metalic
objects and steel reinforced concrete as these reduce the wireless range.
!
Ensure that the location is free of excessive dust, vibration and excessive
heat.
!
There should be suitable mains outlets in the vicinity.
8. Co nnection
Connection of the transmitter
!
Screw the antenna [3] into the antenna connection [2].
!
Connect the video input [8] to the video output of the camera
!
If required, connect the audio input [6] to the audio output of the camera.
If necessary use the adapter [7].
!
Connect the DC-plug of the mains adapter cable [4] to the mains adapter
connection [5] of the transmitter.
!
Connect the mains adapter with a suitable mains outlet. The power-LED
[9] and the connection-LED [10] illuminate and after approx. 3 seconds
the connection-LED is extinguished.
Connection of the receiver
!
Screw the antenna [14] into the antenna connection [13].
!
Connect the video output [20] to the video input of a monitor or recorder. If
required use the adapter [18].
!
If required, connect the audio output [17] to the the audio input of a
monitor or recorder.
!
Connect the DC-plug of the mains adapter cable [15] to the mains adapter
connection of the receiver [16].
!
Connect the mains adapter with a suitable mains outlet. The power-LED
[22] and the connection-LED [21] illuminate and after approx. 3 seconds
the connection-LED is extinguished. If wireless connection is established,
then the connection-LED will illuminate after approx. 4 seconds.
9. Opera tion
!
After connection of the power supplies the set is in operation.
!
Switch on the power for the source and display devices.
20 - GB
!
Select the AV input corresponding to the connection (on some TV sets this
may be depicted as VCR, channel 0, or with the
camera is connected through a recorder then select the corresponding AV
channel. You will now see the picture and hear the sound from the source
device.
!
The orientation of the antennas [3 and 14] can be adjusted to achieve the
best possible connection quality.
Note:
#
If there is no wireless connection the connection-LEDs [10 and 21] will not
illuminate and a message "NO SIGNAL" will appear on the display
monitor. In this case relocate the transmitter and receiver, reducing the
distance if possible. If there is still no connection then the transmitter and
receiver must be paired again (see chapter 10).
#
If the video stops or does not run smoothly adjust the antennas, change the
positions or reduce the distance between the transmitter and receiver.
#
A visual indication of the connection quality can be obtained after
removing the mains adapter [15] of the receiver from the mains supply
and then reconnecting this. A symbol with 0 to 4 bars will then show for
approx. 10 seconds in the top right hand corner of the picture on the
display monitor.
10. Co nnection pairing
The transmitter [1] and receiver [12] must be paired with each other to
establish the wireless connection. The transmitter delivered in the set is already
paired with the receiver.
If required the wireless connection can be established as follows:
!
Check that the cables are correctly connected, that transmitter and receiver
are powered (power LEDs [9 and 22] illuminate on the receiver DF-120RX)
and that these are located within the wireless range.
!
Hold the "Pairing"-button [23]
LED [21] flashes. On the display monitor the following message appears:
"Please press pairing button of TX device" and a timer counts down from 60
seconds.
!
Within the 60 seconds you have time to establish the connection as
follows. Press and hold the "pairing"-button [11]
symbol). If a
on the receiver pressed until the connection
on the transmitter DF-