Makita MP001G Manuel D'instruction page 9

OPERATION
NOTE: The standard adapters vary depending on the
country.
Using the Schrader valve adapter
1. Attach the air chuck to the valve stem.
► 1. Valve stem 2. Air chuck
2.
Turn on the tool, and then set the pressure value
appropriate for the tire using the pressure gauge.
3. Keep pulling the switch trigger until the tool stops.
The tire is inflated with the specified pressure.
Using the Presta valve adapter
1.
Loosen the locking nut on the valve stem.
1
► 1. Locking nut
1
2
2. Attach the Presta valve adapter to the valve
stem, and then attach the air chuck to the Presta valve
adapter.
1
2
► 1. Presta valve adapter 2. Valve stem 3. Air chuck
3.
Turn on the tool, and then set the pressure value
appropriate for the tire using the pressure gauge.
4. Keep pulling the switch trigger until the tool stops.
The tire is inflated with the specified pressure.
5. Remove the air chuck and Presta valve adapter,
and then tighten the locking nut.
Using the sport ball needle
NOTICE:
Be sure to select the ball mode when
you inflate a ball using a sport ball needle. If other
mode is selected, the inflation cannot be performed
properly.
To inflate sport balls, use the sport ball needle.
1. Attach the sport ball needle to the air chuck.
► 1. Air chuck 2. Sport ball needle
2.
Insert the sport ball needle into the hole on the
ball.
3. Turn on the tool.
4. Set the inflation mode to the ball mode, and set
the pressure value appropriate for the ball using the
pressure gauge.
5.
Keep pulling the switch trigger until the tool stops.
The ball is inflated with the specified pressure.
9 ENGLISH
3
1
2