Important - RTI NANO Série Mode D'emploi

Manual: RTI NANO Series
7 blue intensity, positive signal. Difference of 5V
9 yellow intensity, positive signal. Difference of 5V (depending on the version)
10 cyan intensity, positive signal. Difference of 5V (depending on the version) OR: DMX512 IN; positive signal
(Showeditor).
13 Shutter. Difference of 5V
14 x-axis scanner, negative signal. Difference of 10V
15 y-axis scanner, positive signal. Difference of 10V
16 intensity/brightness, negative signal. Difference of 5V
18 red intensity, negative signal. Difference of 5V
19 green intensity, negative signal. Difference of 5V
20 blue intensity, negative signal. Difference of 5V
22 yellow intensity, negative signal. Difference of 5V
23 cyan intensity, negative signal. Difference of 5V OR: DMX512 IN; negative signal
25 Ground
8.3. External Interlock
The Remote Control Pad (optional) has a built-in emergency stop. If there is the need for an
external interlock, please disconnect the Remote Control Pad and use the ‚Control' connection
(RJ-45 connector) to connect it with an external interlock. Interlock in needs a cable with in-
terlock plug.
IMPORTANT: the RTI Interlock Dongle is for testing purposes only!
For a professional laser show you'll need an emergency stop!
8.4. Browser operation instructions
The RTI NANO laser series can be configured via browser over LAN / WiFi. This is possible
through computer, laptop, but also through mobile phones or tablets, if the control signal
is sent over WiFi via a WiFi capable Router / Access Point. Devices connected to the same lo-
cal network as the laser systems are capable to accessing the dedicated laser user interface
through a previously configured IP address or an automatically assigned IP address from a
DHCP server.
If only one single laser shall be configured and the laser system is directly connected to the
control computer by LAN cable, please continue with chapter 8.4.2.1 (a).
8.4.1. DHCP mode - automatic address setting
Requirements: Standard router with DHCP functionality (e.g.: D-Link Wireless AC750 DualBand Easy
Router).
The DHCP mode can be used for the configuration of one or more laser devices.
a. Connect the laser device(s) to the router with an ethernet cable (CAT-5 or higher). Make
sure that DHCP mode is activated on the router and that it is capable to provide an auto-
matic IP address ( see the manual of your router ).
page 8 / 59