Operation - RTI NANO Série Mode D'emploi

Manual: RTI NANO Series
FB4 version
RJ45 for LAN
connection to
computer
with Pangolin
Software
micro SD card
(up to 64 GB)

8. Operation

Please note that when the 'Emission LED' is on, the laser is enabled and may emit laser light.
There is one LED on the remote control pad, one on the rear side and one on the front side of
the device. The LED on the device flashes if the device is connected to the power supply. The
LED on the control pad flashes if the device is switched on.
8.1. Powers supply
Make sure that your device is provided with the correct voltage. Wrong voltage could lead to
irreparable damages. Please find the correct voltage data in the synoptical table at the end
of this manual. It must be ensured that the device is not directed to people or inflammable
objects during installation.
8.2. ILDA control
To control your device connect it via ILDA cables to an interface/controller. The pinout and
maximum voltages for the ILDA standard Sub-D connectors are:
Pin Signal
1 x-axis scanner, positive signal. Difference of 10V
2 y-axis scanner, positive signal. Difference of 10V
3 intensity/brightness, positive signal. Difference of 5V
4 & 17 Interlock. Linking of both enables output
5 red intensity, positive signal. Difference of 5V
6 green intensity, positive signal. Difference of 5V
page 7 / 59
DMX in DMX out
Interlock in
Knob for menu ILDA out
selection
Interlock out
ILDA in
connection for
power supply
fuse 6.3At