Assembly; Touch Display - MAXXMEE 04074 Mode D'emploi

EN

ASSEMBLY

Attaching / Detaching the Microfi bre
Floor Nozzle and Extension Tube
• Attaching: The microfi bre fl oor
nozzle (H) and the extension tube (G)
are plugged directly onto the suction
opening (10). They must engage
audibly. Attach the microfi bre fl oor
nozzle to the extension tube in the
same way.
• Detaching: Press the release but-
ton (11) over the suction opening or
on the extension tube and pull out
the microfi bre fl oor nozzle or the
extension tube at the same time.
Attaching / Detaching the Combi
Nozzle and Crevice Nozzle
• Attaching: Plug the nozzle you want
into the suction opening (10) or the
extension tube (G). When you do this,

TOUCH DISPLAY

On the touch display (6) the following information can be read, the suction strength
can be set manually and the AUTO programme can be switched on.
Battery status display (12)
Roller error display (17)
Suction blockage
error display (16)
Sensor error display (13)
Suction strength (14)
IIIIIII
AUTO AUTO programme (15)
18
make sure that the locking lug on the
nozzle is pointing towards the release
button. The nozzle must engage
audibly.
• Detaching: Press the release but-
ton (11) over the suction opening or
on the extension tube and pull out
the nozzle at the same time.
Detaching / Inserting the Dust
Container
• Detaching: Slide the release but-
ton (5) towards the dust container (3)
and pull it up to detach it.
• Inserting: Insert the dust container
into the motor unit (E) from above.
When you do this, make sure that the
locking lug on the dust container fi ts
in the corresponding recess in the
motor unit. The dust container must
engage audibly.
in per cent, from 10% the battery symbol
and the charge control lamp on the bat-
tery fl ash red
fl ashes red when the roller is blocked /
will not rotate
fl ashes red when the extension tube or
the nozzle is blocked
fl ashes red when the suction strength
control is no longer working, the vacuum
continues to vacuum in manual mode
3 levels can be set, from Eco to High
Speed
automatic suction strength setting
depending on level of dirt etc., is shown
via the ring (18): green = lowest level;
it gradually turns red when the suction
strength is increased; completely red =
highest level