GE Profile PSSF3RGXCWW Manuel Du Propriétaire Et Installation page 5

About the temperature controls.
ge.com
The temperature controls are preset in the factory at 37°F for the
refrigerator compartment and O°Ffor the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
as weft as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer
and refrigerator compartments, but does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
To change the temperature, press and release
the
WARMER or COLDERpad. The SEYlight will come
on and tlle display will show the set temperature.
To change the mmpemmre, tap either
the WARMER
or COLDERpad until the desired
mmpemmre is
displayed. Refiigetator mmpemmres can be
adjusmd between 34°F and 44°F and the fleezer
mmpemmres can be adj usmd bet_,veen
-6°F and +6°E
Once the desired temperature has been set,
the mmpemane display will reu_rn to the acala[
refligemtor and fleezer mmperamres after
5 seconds. Several adjustments may be required.
Each filile yell adjust controls, allow 24 bouI_ f}.)I the
refligemtor to reach the temperature you have set.
To turn the cooling system off, mp the WARMER pad
for eidler the reflJgerator or die fleezer tmdl file
display shows OFF. To turn the unit back on, press the
COLDERpad for either
the refligemtor or fleezer
The
SETlight
will illuminate on the side you
selecmd. Then press the COLDERpad again (on [lle
side where the
SETlight
is illuminamd) and it will
go to the preset points of O°Ffbr the fleezer and
37°Ffor the refligemtor
Setdng either or both
conuols to OFFstops cooling in both the fleezer
and refiigemtor compartments, but does not shut
off electrical power to the refligerator
Performance Air Flow System
The Performance Ai>Flow Sysmm is designed to
maximize temperature control in the reflJgerator
and fleezer comparmlents. This unique special
feature consists of the Ah Tower along the back
wall of the refligerator and the Air Tmmel on the
bottom portion of the fleezer rear wail. Placing food
in flont of the louvers on these components will not
afiect perfbmmnce. 'Although die Air Tower and
the Air Tmmel can be removed, doing so will affe.ct
temperature perfbrmance. (For removal
instructions, onqine, 24 hours a day, contact us at
ge.com or ca/1 800.GE.CARES. In Canada, contact
us at geappliances.ca or ca/1 1.800.561.3344.)
5
.... ,,,,< ...............
!}ii!ii_iiiiii'_ii_iiii
iiiiiii!iiiil_
ea
g
w
u
w
_u