Craftsman CMXGZBF71242131 Guide D'utilisation page 5

ASSembly

CAutIoN: Points of aerator knives are sharp!
exercise caution at all times while assembling
and using the aerator.
Step 1: (fig. 1)
1. Assemble eight aerator knives on the outside of each
double spool assembly. Assemble four aerator knives on
the outside of each single spool assembly. Rotate each
knife to insert the locking tab into the spool plate, then
align the square holes and secure with a 5/16" x 3/4"
carriage bolt (U), and a 5/16" nylock nut (J). See figure 1.
2. Push split plastic bearings (W) into both ends of all
single and double spool assemblies. See figure 1.
5/16" x 3/4"
CARRIAGE BOLT (U)
SPLIT
BEARING (W)
5/16" x 3/4"
CARRIAGE BOLT (U)
SPLIT
BEARING (W)
Fig. 1
Step 2: (fig. 2)
1. Attach the wheel bracket to the hole in the short end
of the shaft using a 1/4" x 1-3/4" hex bolt (B) and a 1/4"
nylock nut (K). Tighten. See figure 2.
SHORT END
OF SHAFT
1/4" x 1-3/4"
HEX BOLT (B)
Fig. 2
5/16"
NYLOCK NUT (J)
SPLIT
BEARING (W)
5/16"
NYLOCK NUT (J)
SPLIT
BEARING (W)
1/4"
NYLOCK NUT (K)
Step 3: (fig. 3)
1. Identify the short end of the shaft. Assemble a, thick
washer (O), 1" long spacer (R), a single spool assembly, a
1.33" long spacer (S), a double spool assembly, another
1.33" long spacer (S), and a 3/4" flat washer (N) onto the
short end of the shaft. See figure 3.
Fig. 3
3/4" FLAT 1.33" LONG
WASHER (N) SPACER (S)
DOUBLE SPOOL
ASSEMBLY (11)
SINGLE SPOOL
ASSEMBLY (9)
Step 4: (fig. 4)
1. Assemble a 1" long spacer (R) and the middle brace (3)
onto the long end of the shaft with the bent end of the
brace facing the wheel bracket. Next, add a 3.70" long
spacer (Q), a single spool assembly, a 1.33" long spacer
(S), a double spool assembly, a 1.33" long spacer (S) and
a 3/4" flat washer (N) onto the long end of the shaft.
See figure 4.
Fig. 4
WHEEL
BRACKET (2)
1" LONG
SPACER (R)
SINGLE SPOOL
ASSEMBLY (9)
DOUBLE SPOOL
ASSEMBLY (11)
1.33" LONG
SPACER (S)
1" LONG SPACER (R)
THICK WASHER (O)
SPLIT
BEARING (X)
SHORT END
OF SHAFT (10)
MIDDLE
BRACE (3)
3.70" LONG
SPACER (Q)
1.33" LONG
SPACER (S)
1.33" LONG
SPACER (S)
3/4" FLAT
WASHER (N)
ENglISh
3